Cisco Systems SPA9000 manual Vertical Service Activation Codes

Chapter 6 SPA9000 Field Reference

	Regional Tab
CPC Delay	Delay in seconds after caller hangs up when the SPA9000 starts removing the tip-and-ring
	voltage to the attached equipment of the called party. Range: 0–255 seconds. SPA9000
	has had polarity reversal feature since release 1.0 which can be applied to both the caller
	and the callee end. This feature is generally used for answer supervision on the caller side
	to signal to the attached equipment when the call has been connected (remote end has
	answered) or disconnected (remote end has hung up). This feature should be disabled for
	the called party (in other words, by using the same polarity for connected and idle state)
	and the CPC feature should be used instead.
	Without CPC enabled, reorder tone will is played after a configurable delay.
	If CPC is enabled, dial tone will be played when tip-to-ring voltage is restored
	Resolution is 1 second.
	The default is 2.
CPC Duration	Duration in seconds for which the tip-to-ring voltage is removed after the caller hangs up.
	After that, tip-to-ring voltage is restored and dial tone applies if the attached equipment
	is still off-hook. CPC is disabled if this value is set to 0. Range: 0 to 1.000 second.
	Resolution is 0.001 second.
	The default is 0 (CPC disabled).

Vertical Service Activation Codes

Vertical Service Activation Codes are automatically appended to the dial-plan. There is no need to include them in dial-plan, although no harm is done if they are included.

Field	Description
Call Return Code	This code calls the last caller.
	The default is *69.
Call Redial Code	Redials the last number called. (Not in PAP2T)
	The default is *07.
Blind Transfer Code	Begins a blind transfer of the current call to the extension specified after the activation
	code.
	The default is *98.
Call Back Act Code	Starts a callback when the last outbound call is not busy.
	The default is *66.
Call Back Deact Code	Cancels a callback.
	The default is *86.
Call Back Busy Act Code	Starts a callback when the last outbound call is busy. (Not in PAP2T)
	The default is *05
Cfwd All Act Code	Forwards all calls to the extension specified after the activation code.
	The default is *72.
	Linksys SPA9000 Administrator Guide
Document Version 3.01		6-29