Delta Electronics VFD-G manual Rev LED is on and FWD led is off. Reverse

			Chapter 4 Parameters
Content	Address		Function
		35~40: Reserved
		41: GFF hardware error (HPF1)
		42: CC,OC hardware error (HPF2)
		43: OC hardware error (HPF3)
		44: OV hardware error (HPF4)
		45: U-phase error (CF3.3)
		46: V-phase error (CF3.4)
		47: W-phase error (CF3.5)
		48: OV or LV (CF3.6)
		49: Isum error (CF3.7)
		50: Temperature sensor error (CF3.8)
Status monitor	2101H	Status of AC drive
Read only		Bit 0-1	00: Run LED is off and stop led is on. (AC Drive
			stopping)
			01: Run LED is blink and stop led is on. (AC
			Drive deceleration to stop)
			10: Run LED is on and stop led is blink. (AC
			Drive standby)
			11: Run LED is on and stop led is off. (AC Drive
			running)
		Bit 2	1: Jog on.
		Bit 3-4	00: Rev LED is off and FWD led is on. (Forward)
			01: Rev LED is blink and FWD led is on.
			(Reverse to Forward)
			10: Rev LED is on and FWD led is blink.
			(Forward to Reverse)
			11: Rev LED is on and FWD led is off. (Reverse)
		Bit 5-7	Reserved
		Bit 8	Master frequency source via communication
			interface
		Bit 9	Master frequency source via analog
		Bit 10	Running command via communication interface
		Bit 11	Parameter locked
		Bit 12-15	Reserved
	2102H	Frequency command (F)
	2103H	Output frequency (H)
	2104H	Output current (AXXX.X)
	2105H	DC-BUS Voltage U (XXX.X)
	2106H	Output voltage E (XXX.X)
	2107H	Power Factor (n)

Revision July 2008, EG03, SW V1.06 4-83