Delta Electronics VFD-G manual Parameter Functions Settings Factory

Chapter 4 Parameters

	Parameter	Functions	Settings	Factory	Customer
				Setting
02-04		Forward/Reverse	00: Forward enabled	00
		Enable	01: Reverse disabled
			02: Forward disabled
02-05		2-wire/3-wire	00: 2-wire: FWD/STOP, REV/STOP	00
		Operation Control	01: 2-wire: FWD/REV, RUN/STOP
		Modes	02: 3-wire operation
02-06		Line Start Lockout	00: Disabled	01
			01: Enabled
02-07		Reserved
02-08		Start-up Display	Bit0~1: 00 = F LED	00
		Selection	01 = H LED
			10 = U LED (special display)
			11 = Fwd / Rev
			Bit2: 0 = Fwd LED /
			1 = Rev LED
			Bit3~5: 000 = 1st 7-step
			001 = 2nd 7-step
			010 = 3rd 7-step
			011 = 4th 7-step
			100 = 5th 7-step
			Bit6~7: Reserved
02-09		Special Display	00: A displays output current of AC drive	00
			01: U displays DC-Bus voltage of AC drive
			02: E displays RMS of output voltage
			03: P displays feedback Signal
			04: PLC display auto procedure state
02-10		User Defined	0.01~160.00	1.00
		Coefficient
02-11		Flying Start	00: Disabled	00
			01: Enable (Dc braking disabled)
02-12		Flying Start	00: Trace from master frequency command	00
		Frequency	01: Trace from maximum setting frequency
			01-00
02-13		Master Frequency	00: Do not remember the last known	01
		Memory Setting	frequency
			01: Remember the last known frequency

4-6 Revision July 2008, EG03, SW V1.06