Delta Electronics VFD-G manual Parameter Functions Settings Factory Customer

Chapter 4 Parameters

	Parameter	Functions	Settings	Factory	Customer
				Setting
			43: HPF3 (OC hardware error)
			44: HPF4 (OV hardware error)
			45: CF3.3 (U-phase error)
			46: CF3.4 (V-phase error)
			47: CF3.5 (W-phase error)
			48: CF3.6 (OV or LV)
			49: CF3.7 (Isum error)
			50: CF3.8 (Temperature sensor error)
00-02		AC Drive Status	Bit 0~1: 00: Run led is off and stop led is on.	Read
		Indication 2	01: Run led is blink and stop led is
			on.
			10: Run led is on and stop led is
			blink.
			11: Run led is on and stop led is off.
			Bit 2: 1: Jog on.
			Bit 3~4: 00: Rev led is off and FWD led is on.
			01: Rev led is blink and FWD led is
			on.
			10: Rev led is on and FWD led is
			blink.
			11: Rev led is on and FWD led is off.
			Bit 5-7: Reserved
			Bit 8: Master frequency source via
			communication interface
			Bit 9: Master frequency source via analog
			Bit10: Running command via communication
			interface
			Bit11: Parameter locked
			Bit12~15: Reserved
00-03		Frequency Setting (F)	Read only	Read
		or Closed Loop
		Control Setting Point
00-04		Output Frequency (H)	Read only	Read
00-05		Output Current (A)	Read only	Read
00-06		DC-BUS Voltage (U)	Read only	Read
00-07		Output Voltage (E)	Read only	Read
00-08		Output Power Factor	Read only	Read
		(n)
00-09		Output Power (kW)	Read only	Read
00-10		Feedback Signal	Read only	Read
		Actual Value
00-11		Feedback Signal (%)	Read only	Read
00-12		User Target Value	Read only	Read
		(Low bit) uL 0-99.99

Revision July 2008, EG03, SW V1.06 4-3