Delta Electronics VFD-G manual Parameter Functions Settings Factory Customer

Chapter 4 Parameters

	Parameter		Functions	Settings	Factory	Customer
					Setting
08-11		Operation Frequency		0.00~160.00 Hz	0.00
		Inhibition 1 UP
08-12		Operation Frequency		0.00~160.00 Hz	0.00
		Inhibition 1 DOWN
08-13		Operation Frequency		0.00~160.00 Hz	0.00
		Inhibition 2 UP
08-14		Operation Frequency		0.00~160.00 Hz	0.00
		Inhibition 2 DOWN
08-15		Operation Frequency		0.00~160.00 Hz	0.00
		Inhibition 3 UP
08-16		Operation Frequency		0.00~160.00 Hz	0.00
		Inhibition 3 DOWN
08-17		Automatic Energy-		00: Energy-saving operation disabled	00
		saving		01: Energy-saving operation enabled
08-18		Automatic Voltage		00: AVR function enabled	00
		Regulation (AVR)		01: AVR function disabled
				02: AVR function disabled for deceleration
08-19		Software Setting of the		740V~820VDC	760
		Braking Level (the		00:Disabled
		action level of the
		braking resistor)
08-20		Vibration		00~1000	00
		Compensation Factor
Group 9 Communication Parameters
	Parameter		Functions	Settings	Factory	Customer
					Setting
09-00		Communication		01-254	01
			Address	00:Disabled
09-01		Transmission Speed		00: Baud rate 4800	01
			(Baud Rate)	01: Baud rate 9600
				02: Baud rate 19200
				03: Baud rate 38400
09-02			Transmission Fault	00: Warn and keep operating	03
			Treatment	01: Warn and RAMP to stop
				02: Warn and COAST to stop
				03: No warning and no display
09-03			Over Time Detection	00: Disabled	00
			during Transmission	01: Enabled
09-04		Communication		00: 7-bit for ASCII	00
			Format	01: 8-bit for ASCII
				02: 8-bit for RTU

Revision July 2008, EG03, SW V1.06 4-15