Delta Electronics VFD-G manual Description of Parameter Settings

Chapter 4 Parameters

4.3 Description of Parameter Settings

Group 0: User Parameters : This parameter can be set during operation.

00 - 00 Software Version

Factory setting: Read Only

This parameter displays the software version of AC drive.

00 - 01 AC Drive Status Indication 1

				Factory setting: Read Only
	This parameter displays the AC drive status.
	Code	AC Drive Status	Explanation
	00	No fault occurred
	01	oc	over current
	02	ov	over voltage
	03	oH	over temperature
	04	oL	overload
	05	oL1	electronic thermal relay
	06	EF (external fault)	EF-DCM is closed
	07	occ (AC drive IGBT fault )	IGBT short circuit protection
	08	CF3 (CPU failure)	Abnormal A/D reading during self-check
09		HPF (hardware protection	Hardware protection function activated during self-check.
		failure)
10		ocA (over current during	Output current exceeds protection level during
		acceleration)	acceleration
11		ocd (over current during	Output current exceeds protection level during
		deceleration)	deceleration
12		Ocn (over current during	Output current exceeds protection level during steady
		steady state)	state operation.
	13	GFF (ground fault)	Ground fault protection feature activated
	14	Lv (under voltage)	Low input voltage
	15	CF1	EEPROM input data is abnormal
	16	CF2	EEPROM output data is abnormal
	17	bb (base block)	BB is set and activated
	18	oL2 (over load 2)	Output current exceeds rated motor current
	19	Reserved
	20	codE	software or password protection
21		EF1 (external emergency	EF1 (a multifunction-DCM is enabled)
		stop)

Revision July 2008, EG03, SW V1.06 4-23