HP 132A, 53131A Front Panel to SCPI Command Maps, Table 2-1.IEEE 488.2 Common Commands (Continued)

Chapter 2 Command Summary

Front Panel to SCPI Command Maps

Table 2-1. IEEE 488.2 Common Commands (Continued)

Mnemonic		Command Name	Function
*OPT?		Option Identification Query	Identifies the options installed in the Counter.
*PMC		Purge Macro Command	Deletes all macros previously defined using the
			*DMC command.
*RCL	<NRf>	Recall	Restores the state of the Counter from a copy stored
			in local non-volatile memory (0 through 20 are valid
			memory registers).
*RST		Reset	Resets the Counter to a known state.
*SAV	<NRf>	Save	Stores the current state of the Counter in local non-
			volatile memory (1 through 20 are valid memory
			registers).
*SRE	<NRf>	Service Request Enable	Set the Service Request Enable register.
*SRE?		Service Request Enable Query	Queries the Service Request Enable register.
*STB?		Status Byte Query	Queries the Status Byte and Master Summary Status
			bit.
*TRG		Trigger	This trigger command is the device-specific analog
			of the IEEE 488.1 defined GET.
			It initiates measurement, unless *DDT was used to
			redefine device trigger.
*TST?		Self-Test Query	Executes an internal self-test and reports the results.
			Makes Counter wait until all pending operations (see
*WAI		Wait-to-Continue	Note) are completed before executing commands
			following *WAI command.

Note: Pending operations include measurements in progress.

Programming Guide 2-23