HP 53131A, 132A Keyword/Syntax Parameter Form Std Comments New INITiate, INPut12, INPut3, MEASure

Chapter 2 Command Summary

Front Panel to SCPI Command Maps

Table 2-2. HP 53131A/132A SCPI Command Summary (Continued)

Keyword/Syntax	Parameter Form	Std/	Comments
		New
:INITiate		Std	Subsystem. Controls the initiation of measurements.
:AUTO	<Boolean>	New	AUTO ON enables the Counter to automatically stop
			measuring on a limit test failure. AUTO OFF
			disables the automatic stop.
:CONTinuous	<Boolean>	Std	Sets the enable for continuously initiated
			measurements.
[:IMMediate]		Std	Event; no query. Causes the instrument to initiate
			the number of measurements specified by
			:TRIGger:COUNt:AUTO.
:INPut[12]		Std	Subsystem. Controls the characteristics
			of the instrument ’s input ports. :INPut1= channel 1
			and :INPut2= channel 2
:ATTenuation	1 10	Std	Sets input attenuation.
:COUPling	AC DC	Std	Sets input coupling.
:FILTer		Std	Subtree. Allows a low pass filter to be inserted in the
			path of the measurement signal.
[:LPASs]		Std	Subtree. Controls the Low PASs filter.
[:STATe]	<Boolean>	Std	Sets the Low PASs filter enable.
:FREQuency?		Std	Query only. Returns the cutoff frequency of the low
	<numeric_value>	Std	pass filter. Units are Hertz.
:IMPedance			Sets input impedance (50 Ω or 1 M Ω ).
	[OHM]
:INPut3		Std	Subsystem. Queries the characteristics of the
			Counter’s input channel 3.
:COUPling?		Std	Query only. Returns channel 3 input coupling.
:IMPedance?		Std	Query only. Returns channel 3 input impedance.
:MEASure		Std	See Measurement Instructions in this table.

Programming Guide 2-29