HP 132A, 53131A manual Keyword/Syntax Parameter Form Std Comments New CALCulate2, CALCulate3

Chapter 2 Command Summary

HP 53131A/132A Command Summary

Table 2-2. HP 53131A/132A SCPI Command Summary (Continued)

Keyword/Syntax	Parameter Form	Std/	Comments
		New
:CALCulate2 (Cont.)
:LIMit (Cont.)		Std	Subtree. An abbreviation for Fail COunt.
:FCOunt
:LOWer?		New	Query only. Returns the number of limit test
			failures at the lower limit.
:UPPer?		New	Query only. Returns the number of limit test
			failures at the upper limit.
[:TOTal]?		New	Query only. Returns the total number of
			measurements that failed the limit test.
:LOWer		Std	Subtree.
[:DATA]	<numeric_value> [HZ S	Std	Sets lower limit used in limit testing.
	DEG]
:STATe	<Boolean>	Std	Sets the limit test enable. Note that this setting
			must be enabled for any of the other :CALC2
			settings can be used.
:UPPer		Std	Subtree.
[:DATA]	<numeric_value> [HZ S	Std	Sets upper limit used in limit testing.
:PCOunt	DEG]	New	Subtree. An abbreviation for Pass COunt.
[:TOTal]?		New	Query only. Returns the total number of
			measurements that passed the limit test.
:CALCulate3		Std	Subsystem. Performs post-acquisition statistics
			computation and data transfer.
:AVERage		Std	Subtree. Collects together the commands
			associated with the Statistics capabilities.
:ALL?		New	Returns all four Statistics results (i.e., mean,
			standard deviation, maximum, and minimum).
:CLEar		Std	Event; no query. Clears the statistics results
			and statistics count.
:COUNt	<numeric_value>	Std	Selects number of measurements to combine
			for statistics.
:CURRent?		New	Query only. Returns the current number of data
			values collected, thus far.
[:STATe]	<Boolean>	Std	Enables/disables statistics post-processing.
			Note that this setting must be enabled for any
			of the other :CALC3 settings to be used.
:TYPE	MAXimum MINimum	Std	Selects which statistic will be in
	SDEViation SCALar or		:CALC3:DATA?,and on the front-panel display.
:DATA?	MEAN	Std	Query only. Returns statistic result specified by
			:CALC3:AVER:TYPE.
:FEED	“[:]CALCulate[1] ”	Std	Sets the data flow to be fed into the
			CALCulate3 block.

2-26 Programming Guide