HP Pro 4300 C9H70UT C9H70UT#ABA manual Output delivery assembly

Output delivery assembly

1.Remove the following assemblies:

●Top cover. See “Top cover” on page 146.

●Rear output bin. See “Rear output bin” on page 155.

2.Release the locking pin on the shaft lock and rotate the lock toward the rear of the printer until the inner retaining tab (gear side) aligns with the hole in the output delivery assembly frame. Slide the shaft lock to the right and remove it to release the gear shaft from the output delivery assembly.

Hint	Snap the shaft lock back into place on the assembly so that you will not lose it. Remove the shaft
	lock when you reinstall the output delivery assembly. When the output delivery assembly is
	installed, verify that the locking pin on the shaft lock is fully seated in the hole on the output delivery
	assembly.

Figure 102. Output delivery assembly (rear view, formatter side; 1 of 2)

Q2431-90912 Chapter 6 Removing and replacing parts 163