HP Pro 4300 C9H70UT C9H70UT#ABA Stapler/stacker LED is, Error applies to the stapler/stacker

Table 41. Alphabetical printer messages (continued)

Message	Description	Action
STAPLER LOW ON STAPLES	Fewer than 70 staples remain in	1.	Press the HELP (	) button
For help press	the optional stapler/stacker staple	2.	for detailed information.		)
	cartridge. Printing will continue		Press the UP ARROW (
Note:	until the STAPLER OUT OF STAPLES		button and the
	message appears on the printer		DOWN ARROW (	) button to
The stapler/stacker LED is	control-panel display.		step through the instructions.
continuously illuminated green (this		3. If after following the
error applies to the stapler/stacker			instruction above this error
only).			persists, replace the staple
			unit. See “To remove and
			replace the stapler unit” on
			page 60.
		NOTE:
		The customer is responsible for
		ordering replacement staple
		cartridges.
STAPLER OUT OF STAPLES	Fewer than 15 staples remain in	1.	Press the HELP (	) button
For help press	the optional stapler/stacker. The	2.	for detailed information.		)
	printer behavior depends on how		Press the UP ARROW (
Note:	STAPLES OUT is configured.		button and the
	● If STAPLES OUT=STOP, the		DOWN ARROW (	) button to
The stapler/stacker LED blinks in			step through the instructions.
	printer stops printing until you
amber (this error applies to the		3.	Replace the staple cartridge.
	refill the stapler or press the
stapler/stacker only).		4.	If this error persists, Replace
	SELECT ( ) button. This is the
			the stapler unit (see “To
	default setting.
			remove and replace the
	● If STAPLES OUT=CONTINUE,
			stapler unit” on page 60)
	printing continues but following
			followed by the
	jobs will not be stapled.
			stapler/stacker if necessary.
TOO MANY PAGES IN JOB TO	The maximum number of sheets	Reduce the number of pages in
STAPLE	the stapler can staple is 15. The	the print job, or print and staple in
	print job finishes printing but is not	batches of 15 or fewer pages.
Note:	stapled.
The stapler/stacker LED is
continuously illuminated in green
(this error applies to the stapler/
stacker only)
TOO MANY TRAYS INSTALLED	Too many optional input trays are	Turn off the printer power and
Turn power off and unistall a	installed. A maximum of two	remove a tray.
tray.	optional trays is allowed.

Q2431-90912 Chapter 7 Troubleshooting 269