Maintaining the stapler unit

Removing and replacing the stapler unit

Use this procedure to replace a defective stapler unit in the optional stapler/stacker.

To remove and replace the stapler unit

1.Locate the stapler unit on the right side of the stapler/stacker.

2.Rotate the stapler unit toward the front of the printer until the unit clicks. Hold the stapler unit in this open position.

3.Push down on the tab at the top of the stapler unit.

4.Hold the tab down and pull the stapler unit up and out of the stapler/stacker.

5.Disconnect the cable that connects the stapler unit to the stapler/stacker. (Only the blue part detaches.)

1

4

2

5

3

Figure 3.Replacing the stapler unit (1 of 2)

60 Printer maintenance

Q2431-90912

Page 80
Image 80
HP Pro 4300 C9H70UT C9H70UT#ABA manual Maintaining the stapler unit, Removing and replacing the stapler unit