HP Pro 4300 C9H70UT C9H70UT#ABA manual Paper-pickup assembly 3

4.Unplug the paper-pickup gear assembly solenoid (callout 4) connector from the

DC controller PCA (location J92; callout 5). Unweave the solenoid wire-harness from the wire guide and the cable clips (callout 6).

Hint	It might be necessary to remove additional wire-harnesses from the wire guide to gain access to
	the solenoid wire-harness.

5

6

4

Figure 133. Paper-pickup assembly (3 of 5)

5.Remove four screws (callout 7). Reach inside the printer and push the rear tray 2 feed roller up into its raised position (see “Tray 2 feed rollers (4 of 4)” on page 142). This disengages the roller lifting arm (callout 8) from the clutch gear.

8

7

Figure 134. Paper-pickup assembly (4 of 5)

184 Removing and replacing parts Q2431-90912