HP Pro 4300 C9H70UT C9H70UT#ABA manual Stapler/stacker LED blinks, Removing and replacing

Table 42. Numerical printer messages (continued)

Message	Description	Action
13.12.07	There is a jam in the stapler	1.	Press the HELP (	) button
JAM IN STAPLER	cartridge (the stapler did not finish		for detailed information.
	stapling but its motor was able to	2.	Press the UP ARROW (		)
Note:	return to its home position).		button and the
The stapler/stacker LED blinks in			DOWN ARROW (	) button to
			step through the instructions.
amber (this error applies to the
		3.	Remove any jammed paper
stapler/stacker only).
			from the stapler/stacker.
		4.	Remove the staple cartridge
			from the stapler unit.
		5.	Push the green door on the
			end of the staple cartridge up
			(in the direction of the
			arrows).
		6.	Remove the jammed staple.
		7.	Close the staple cartridge
			door. Replace the cartridge in
			the stapler unit.
		8.	Close the staple unit.
		9.	If the error persists, replace
			the staple cartridge.
		10. If the error persists, replace
			the stapler unit. See
			“Removing and replacing the
			stapler unit” on page 60.
13.12.08	The output bin page-detection	1.	Press the HELP (	) button
JAM IN OUTPUT DEVICE	sensor has been active for longer		for detailed information.
	than the specified time.	2.	Press the UP ARROW (		)
Note:			button and the
The stapler/stacker LED blinks in			DOWN ARROW (	) button to
			step through the instructions.
amber (this error applies to the
		3.	Remove all of the pages from
stapler/stacker only).
			the output bin.
		4.	Open the jam-access door
			and remove all of the pages.
			Close the access door.
		5.	If this error message persists,
			replace the stapler/stacker.
13.12.09	The stacker or staple/stacker	1.	Press the HELP (	) button
JAM IN OUTPUT DEVICE	inlet sensor has been active for		for detailed information.
For help press	longer than a specified time.	2.	Press the UP ARROW (		)
			button and the
Note:			DOWN ARROW (	) button to
The stacker or stapler/stacker LED			step through the instructions
		3.	Open the jam-access door
blinks in amber.
			and remove all of the pages.
			Close the access door.
		4.	If this error message persists,
			replace the stacker or
			stapler/stacker.

Q2431-90912 Chapter 7 Troubleshooting 279