HP Pro 4300 C9H70UT C9H70UT#ABA manual Jetdirect

Jetdirect page

A

B

D

C

Figure 205. Jetdirect page

A.HP Jetdirect Configuration If the EIO Jetdirect card properly installed and the printer completes its internal diagnostics, the I/O CARD READY status message prints. If communication is lost, an I/O NOT READY status message prints, followed by a two-digit error code. See the

HP Jetdirect Network Interface Configuration Guide for further details and recommended action.

B.	Network Statistics	This block indicates that network activity has been occurring. Bad
		packets, framing errors, unsendable packets, and collisions should be
		minimal. If a high percentage (greater than one percent) of these
		occur, contact the network administrator. All of the statistics are set to
		zero when the printer is turned off.
C.	TCP/IP	In this block, the default IP address is “192.0.0.192.” you can operate
		the printer with this default address. The error message ARP
		DUPLICATE ADDRESS might appear in this block. This is also an
		acceptable error code if the TCP/IP protocol is not being used. Check
		with the network administrator to determine the correct IP address for
		the printer. To configure the printer’s IP address, go to the control
		panel EIO menu, select CFG NETWORK=YES, select CFG TCP/IP=YES,
		and then select BOOTP=NO.
D.	Novell/NetWare	This block should state the name of the Novell printer server to which
		the printer is connected. If the node name reads “NPIxxxxxx” (where

xxxxxx= the last six digits of the EIO’s LAN address), the EIO card has not been configured for a Novell server. This could indicate that the card is operating under protocol other than Novell. Check with the network administrator to determine what node name might be appropriate.

256 Troubleshooting Q2431-90912