HP Pro 4300 C9H70UT C9H70UT#ABA System Setup submenu, System setup submenu Values Explanation

System Setup submenu

Items on this menu affect printer behavior. Configure the printer according to your printing needs.

The following section lists the settings and their possible values in the System Setup submenu. The default value for each setting is the one that has an asterisk (*) next to it.

Table 24. System setup submenu

Item	Values	Explanation
JOB STORAGE LIMIT	1 to 100 (*32)	Use this item to specify the number of quick copy jobs
		that can be stored on the printer. This item appears only
		if an optional hard disk accessory is installed.
JOB HELD TIMEOUT	*OFF	Use this item to set the amount of time that held jobs are
	1 HOUR	retained before being automatically deleted from the
	4 HOURS	queue.
	1 DAY
	1 WEEK
TRAY BEHAVIOR	● USE	Determines whether the printer tries to pull media from a
● USE REQUESTED TRAY	REQUESTED	tray other than the one that was selected in the printer
● MANUAL FEED PROMPT	TRAY	driver.
	Exclusively	EXCLUSIVELY: Sets the printer to pull media only from the
	*First	tray that you selected and not from another tray, even if
		the tray you selected is empty.
		FIRST: Sets the printer to pull first from the tray that you
		selected, but then to pull from another tray automatically
		if the tray you selected is empty.
	● MANUAL FEED	Use this item to tell the printer to show a prompt about
	PROMPT	pulling from tray 1 if the print job does not match the type
	Always	or size loaded in any other tray.
	*Unless Loaded	ALWAYS: Select this option if you always want to be
		prompted before the printer pulls from tray 1.
		UNLESS LOADED: Prompts you only if tray 1 is empty.
POWERSAVE TIME	1 MINUTE	Use this item to set how long the printer remains idle
	15 MINUTES	before it enters the PowerSave mode.
	*30 MINUTES	PowerSave mode does the following:
	60 MINUTES	● minimizes the amount of power the printer consumes
	90 MINUTES
		when it is idle
	2 HOURS
		● reduces wear on electronic components in the printer
	4 HOURS
		(turns off the display backlight, but the display is still
		readable)
		The printer automatically comes out of PowerSave mode
		when you send a print job, press a printer control-panel
		button, open a tray, or open the top cover.
PERSONALITY	*AUTO	Use this item to select the default printer language
	PS	(personality). The available values depend on which valid
	PCL	printer languages are installed in the printer.
		Normally, you should not change the printer language. If
		you change it to a specific printer language, the printer
		will not switch automatically from one language to
		another unless specific software commands are sent to
		the printer.

Q2431-90912 Chapter 3 Printer operation 49