HP Pro 4300 C9H70UT C9H70UT#ABA manual Paper-pickup assembly 1

Paper-pickup assembly,

1.Remove the following assemblies:

●Top cover. See “Top cover” on page 146.

●Right-side cover. See “Right-side cover” on page 149.

2.Remove one e-clip (callout 1) and the shaft collar (callout 2). Lift the power-switch connector-bar (callout 3) up and swing it away from the paper-pickup gear assembly.

3

1

2

Figure 131. Paper-pickup assembly (1 of 5)

3.From the right side of the printer, push the tray drive-gear/shaft into the tray 2 cavity and remove it.

Note	The large gear inside of the paper-pickup assembly is not captive and will slide off of the shaft
	and be loose inside the paper-pickup assembly (see “Tray 2 drive gear and shaft” on page 185).

Figure 132. Paper-pickup assembly (2 of 5)

Q2431-90912 Chapter 6 Removing and replacing parts 183