HP Pro 4300 C9H70UT C9H70UT#ABA manual Submenu, O submenu Values Explanation

I/O submenu

Items on the I/O (input/output) menu affect the communication between the printer and the computer. The contents of the I/O submenu depend on which EIO card is installed.

The following section lists the settings and their possible values in the I/O submenu. The default value for each setting is the one that has an asterisk (*) next to it.

Table 26. I/O submenu

Item	Values	Explanation
I/O TIMEOUT	5 to 300 (*15)	Select the I/O timeout period in seconds.
		This setting allows you to adjust timeout for best
		performance. If data from other ports appear in the middle
		of your print job, increase the timeout value.
PARALLEL INPUT	● HIGH SPEED	Select YES to enable the printer to accept the faster parallel
● HIGH SPEED	NO	communications that are used for connections with newer
● ADVANCED	*YES	computers.
FUNCTIONS		Turn the bidirectional parallel communication on or off. The
	● ADVANCED
	FUNCTIONS	default is set for a bidirectional parallel port (IEEE-1284).
	OFF	The function allows the printer to send status readback
	*ON	messages to the computer. (Turning the parallel advanced
		functions on might slow language switching.)
EIO [X]	CFG NETWORK	The [X] represents the slot in which the optional
JETDIRECT MENU	YES	HP Jetdirect print server is installed, if any. Which of the
	NO	following submenus appears depends on the type of print
		server that is installed. Use this item to select
		CFG NETWORK = YES to access the available submenus
		listed below.
TCP/IP	● ENABLE	Select whether the TCP/IP protocol stack is enabled or
● ENABLE	OFF	disabled. You can set several TCP/IP parameters.
● CONFIG METHOD	*ON
	● CONFIG METHOD	Select the TCP/IP configuration method.
	*BootP	For the	MANUAL	option, set the values for	IP ADDRESS
					,
	DHCP	SUBNET MASK, DEFAULT GATEWAY, SYSLOG SERVER, and IDLE
	MANUAL	TIMEOUT.
IPX/SPX	● ENABLE	Select whether the IPX/SPX protocol stack (in Novell
● ENABLE	OFF	NetWare networks, for example) is enabled or disabled.
● FRAME TYPE	*ON
	● FRAME TYPE	Select whether the frame type is automatically determined
	*AUTO	or turned off.
	OFF
APPLETALK	● ENABLE	Select whether the Apple EtherTalk protocol stack is
● ENABLE	OFF	enabled or disabled.
	*ON
DLC/LLC	● ENABLE	Select whether the DLC/LLC protocol stack is enabled or
● ENABLE	OFF	disabled.
● LINK SPEED	*ON
	● LINK SPEED	Selects the network link speed (10 or 100 Mbps) and the
	*AUTO	communication mode (full-duplex or half-duplex).
	10T HALF
	10T FULL
	100TX HALF
	100TX FULL

52 Printer operation Q2431-90912