To close Management Application

1 Click [ (Close)]

2 Select [Save changes - restart services], and click [OK].

Management Application is closed.

Caution:

Never turn off the power while saving settings of Management Application.

When you change settings of Management Application, restart the Management Application service; otherwise, the new settings are not applied.

Connecting Cameras

Use the [Add Hardware Devices...] wizard to register cameras in the network with the system and enable setup and operations from NVR.

User name and password for each camera are necessary for camera registration. Please check them in advance. For details, refer to the instruction manual of the cameras.

Caution:

You need to configure an IP address for each network camera in advance.

By default, the IP address for LAN1 is 192.168.0.253 and the subnet mask is 255.255.255.0.

It is necessary to set the IP address of the network camera in the same segment* as LAN1 of this unit. If the camera and this unit are not on the same network, the camera cannot be registered. Confirm that the IP address of the camera and LAN1 are in the same segment. If they are in different segments, consult your network administrator.

Example: When the subnet mask is 255.255.255.0

IP address of this unit: 192.168.0.253

IP address of the camera: 192.168.0.100

*Segment: Underlined sections

Do not set multiple devices to the same IP address. Otherwise, settings cannot be made correctly.

1 Click [Add Hardware Devices...]

The wizard will start.

Check to ensure that the [Express (recommended)] check box is selected.

2 Click [Next]

Automatic detection of cameras connected to the network starts. When the automatic detection is completed, a list of cameras detected appears.

Depending on the network configuration, the camera may not be detected automatically. Click [Rescan] when there is any camera that is not shown in the list. When the camera is still not shown, register the camera manually. (A Page 117 "Manually Registering a Camera")

VN-C215U will not be detected automatically. Please register it manually. (A Page 117 "Manually Registering a Camera")

If the user name and password of a camera have been changed from the initial settings, there is a chance that the camera will not be automatically detected.

33

Page 39
Image 39
JVC VR-X1600U, VR-X3200U manual Connecting Cameras, Click Add Hardware Devices, Click Next