JVC VR-X3200U, VR-X1600U manual 136, Computer

<Viewer Part> Basics

Viewer Description	Installing the Viewer on a
(continued)	Computer

Note:

●The Smart Client logs in to a distribution server within the VR-X3200U/VR-X1600U to operate.

●Embedded Smart Client also logs in to the distribution server of this unit (http://localhost or http://127.0.0.1). By default, it is configured to automatically log in to this unit. For how to log in, refer to AStarting Smart ClientB

(A Page 133).

●If surveillance computers of the maximum number of clients are connected, you cannot log into the Smart Client built into this unit.

Caution:

●If you have changed recording settings using the Management Application, log out from the Smart Client and then log in again. (A Page 133)

●By default, you can log in to the system by just clicking [Connect] in the [Connect to Server] screen.

When you have changed the settings, refer to descriptions from Step 2 in the “Starting Smart Client” section

(A Page 133).

●Even in the following situations, you may restore the system by restarting the Smart Client:

●Live images and playback screen black out.

●Operations of the Smart Client are slow.

●The Smart Client is not responding.

●In the Smart Client, images and audio sounds may be out of synchronization.

●If you have configured e-mail settings, conduct a test to ensure that e-mails will be sent. (A Page 110)

●If you have connected an additional HDD, startup may take several minutes.

●Be sure to set the Smart Client so that the live frame rate does not exceed the performance of this unit; otherwise, the recording frame rate may decrease. For the performance of this unit, see ARecording/Displaying live images/Distribution performanceB (A Page 196).

●Avoid continuous playback of recorded images (for longer than 1 hour) as it may cause recording failure.

Installing the viewer (Smart Client) on a computer connected to NVR and network will allow for:

●Viewing live images on the computer

●Controlling network cameras on the computer

●Viewing recorded images on the computer

Caution:

●Connect the computer to the LAN2 network.

●Settings for cameras connected to the LAN1 network cannot be specified from a computer connected to the LAN2 network.

136