43
7 Select the preset positions you want to use in
the [Preset Positions], and click [ ]
Doing so copies the selected preset positions to the
[Patrolling list].
●A preset position can be used more than once in a
patrol scheme.
●The camera will move between the preset positions in
the sequence shown in the [Patrolling list], starting from
the top position.
●To change the sequence of preset positions in the
[Patrolling list] list, select a preset position name, and
click [ ][ ].
●To remove a preset position from the [Patrolling list],
select the preset position and click [ ].
8 Specify patrol timing
9 Click [OK]
䡵Pause patrolling when any motion is detected
1 Select the [Pause patrolling if motion is
detected] check box in the PTZ patrolling screen
2 Select the conditions for resuming PTZ
patrolling and specify units of seconds
䡵Resume patrolling paused manually or by any
event
Patrolling is paused at the time of manual PTZ operations or
occurrence of any event.
Time to resume paused patrolling is specified in [Resume
PTZ patrolling after:] in [Pause patrolling] in the PTZ
patrolling screen.
Note:
●The settings in this section are applied to all PTZ cameras
installed in the system.
䡵PTZ Scanning
For cameras that support PTZ scanning, enable this feature
by selecting the [PTZ scanning] check box. You may select a
PTZ scanning speed.
Item Description
Wait time (sec.) For specifying the down time (in
seconds) at each preset position.
Transition time
(sec.)
For specifying the time (in seconds)
that the PTZ camera takes to move
between the preset positions.
The motion detection is disabled
during the transition time.
Item Description
seconds after
first motion
detection
For resuming patrolling when a
specific time interval has lapsed after
the first detected motion, regardless
of whether any subsequent motion is
detected.
seconds after last
motion is
detected
For resuming patrolling when a
specific time interval has lapsed after
the last detected motion.