JVC VR-X1600U  Connecting external security devices,  Rear input terminals, Terminal Remarks

Connecting external security devices

Connect devices other than network devices (infrared sensor and warning system, etc.) to the signal input terminals on the rear panel.

Rear input terminals

Terminal							Remarks
[ALARM IN]	 Name of input event:			 Name of input event:			Make Contact Input
	JVC NVR ALARM IN1 to 8 MAKE			JVC NVR ALARM IN1 to 8 BREAK
		(Generic events)			(Generic events)
			250ms or more			250ms or more
			Make			Break
	Note:
	● Set the impedance at the output end to 10kK or lower.
[WARNING							Make Contact Input
RESET]

250ms or more

Note:

●Set the impedance at the output end to 10kK or lower.

[OPE ON/OFF]								Make Contact Input
			Approx.		1s or more
			50ms
		OPE ON				OPE OFF
	Note:
	● Set the impedance at the output end to 10kK or lower.
	● The "OPERATE OFF" works even during Operation Lock. ( A Page 116)
[REC TALLY]								Open collector output
[WARNING OUT]								(DC15V, 10 mA and
				Make Output				below)
							(External Pull-up
							Level)
	The make contact is formed using the individual output terminals and the
	[COMMON] terminal. Turning off the power of this unit switches the output of the
	output terminals to break.

27