Multi-Tech Systems MVP-3010, MVP-2400, MVP-2410 manual Introduction, MultiVOIP Startup Tasks

MultiVOIP User Guide Quick Start Instructions

Introduction

This chapter gets the MultiVOIP up and running quickly. The details we’ve skipped to make this brief can be found elsewhere in the manual (see Table of Contents and Index).

MultiVOIP Startup Tasks

Task	Summary
● Collecting Phone/IP	The MultiVOIP must be configured to
Details (vital!)	interface with your particular phone system
	and IP network. To do so, certain details
	must be known about those phone and IP
	systems.
● Placement	Decide where you’ll mount the voip.
● Command/Control	Some modest minimum specifications must
Computer Setup:	be met. A COM port must be set up.
Specs & Settings
● Hookup	Connect power, phone, and data cables per
	diagram.

●Software Installation

This is the configuration program. It’s a standard Windows software installation.

●Phone/IP Starter Configuration

●Phonebook Starter Configuration

You will enter phone numbers and IP addresses. You’ll use default parameter values where possible to get the system running quickly.

The phonebook is where you specify how calls will be routed. To get the system running quickly, you’ll make phonebooks for just two voip sites.

●Connectivity Test

●Troubleshooting

You’ll find out if your voip system can carry phone calls between two sites. That means you’re up and running!

Detect and remedy any problems that might have prevented connectivity.

47