Multi-Tech Systems MVP-2400, MVP-2410, MVP-3010 Screw locations 2 at phone-jack edge of board, 546

8-Channel Analog Expansion Card MultiVOIP User Guide

8.On the phone-jack side of the circuit card, three screws attach the circuit card to the back panel. Two of these screws are adjacent to the four phone- jack pairs. Remove these two screws.

Screw locations (2) at phone-jack edge of board.

Figure D-5: Screws to be removed and replaced with standoffs (phone-jack edge of board; top view)

9.Replace these two screws with standoffs.

10.There are two copper-plated holes at the LED edge of the circuit card. Place a nut beneath each hole (lockwasher side should be in contact with board) and attach a standoff to each location).

Standoff locations (2) at LED edge

of board (top view).

Standoff/nut attachment

(rear bottom view)

Figure D-6: Standoffs at LED edge of board (top view)

546