Multi-Tech Systems MVP-2400 Connectivity Test, MultiVOIP User Guide Quick Start Instructions

MultiVOIP User Guide Quick Start Instructions

Connectivity Test

The procedures “Phone/IP Starter Configuration” and “Phonebook Starter Configuration” must be completed before you can do this procedure.

1. These connections must be made:

Connections
for digital MultiVOIPs	for analog MultiVOIPs
(MVP-2400/2410/3010	(MVP-130/210/410/810,
	MVP-210G/410G/810G)
MultiVOIP to local PBX	MultiVOIP to local phone
	station
	–OR--
	MultiVOIP to extension of key
	phone system
MultiVOIP to command PC	MultiVOIP to command PC
MultiVOIP to Internet	MultiVOIP to Internet

2.Inbound Phonebook and Outbound Phonebook must both be set up with at least one entry in each. These entries must allow for connection between two voip units.

3.Console messages must be enabled. (If this has not been done already, go, in the MultiVOIP GUI, to Configuration Logs and select the “Console Messages” checkbox.

4.You now need to free up the COM port connection (currently being used by the MultiVOIP program) so that the HyperTerminal program can use it. To do this, you can either (a) click on Connection in the sidebar and select “Disconnect” from the drop-down box, or (b) close down the MultiVOIP program altogether.

81