MultiVOIP User Guide

Mechanical Installation

 

 

 

Cabling Procedure for MVP130

Power

Ethernet Command

FXS/FXO

Power Connection

 FXS

Command Port Connection

 

Telephony Connection

Hub

Network Connection

FXO

PBX

PSTN

Figure 3-14: Cabling for MVP130

Cabling involves connecting the MultiVOIP to your LAN and telephone equipment.

1.Connect the power cord supplied with your MultiVOIP to the power connector on the back of the MultiVOIP and to a live AC outlet as shown in Figure 3-14.

2.Connect the MultiVOIP to a PC by using a RJ-45 (male) to DB-9 (female) cable. Plug the RJ-45 end of the cable into the Command port of the MultiVOIP and the other end into the PC serial port. See Figure 3-14.

3.Connect a network cable to the ETHERNET 10/100 connector on the back of the MultiVOIP. Connect the other end of the cable to your network.

4.If you are connecting a station device such as an analog telephone, a fax machine, or a Key Telephone System (KTS) (FXS interface), or a PBX extension (FXO interface) to your MultiVOIP, connect one end of an RJ-11 phone cord to the Channel 1 FXS/FXO connector on the back MultiVOIP and the other end to the device or phone jack. You will define the interface in the Interface dialog box in the software when you configure the unit.

Proceed to Chapter 4 to load the MultiVOIP software.

107

Page 107
Image 107
Multi-Tech Systems MVP-3010, MVP-2400, MVP-2410 manual Cabling Procedure for MVP130, 107