Multi-Tech Systems MVP-3010, MVP-2400, MVP-2410 Cabling Procedure for MVP2400, Cabling for MVP2400

Mechanical Installation MultiVOIP User Guide

4.Turn on power to the MultiVOIP by setting the power switch on the right side panel to the ON position. Wait for the Boot LED on the MultiVOIP to go off before proceeding. This may take a couple of minutes.

Proceed to Chapter 4 “Software Installation.”

Cabling Procedure for MVP2400

Cabling your MultiVOIP entails making the proper connections for power, command port, phone system (T1 line connected to PBX or telco office), and Ethernet network. Figure 3-10 shows the back panel connectors and the associated cable connections. The following procedure details the steps necessary for cabling your MultiVOIP.

1.Connect the power supply to a live AC outlet, then connect it to the MultiVOIP as shown in Figure 3-10.

DIGITAL VOICE

TRUNK

ETHERNET COMMAND

			1
10/100	RS232	POWER	0

Power Connection

T1

PBX

PSTN

Telephony Connection

Command Port Connection

Network Connection

Hub

Figure 3-10: Cabling for MVP2400

2.Connect the MultiVOIP to the PC (the computer that will hold the MultiVOIP software) using the RJ-45 to DB9 (female) cable provided with your unit. Plug the RJ-45 end of the cable into the Command port of the MultiVOIP and connect the other end (the DB9 connector) to the PC serial port you are using (typically COM1 or COM2). See Figure 3-10.

3.Connect a network cable to the Ethernet connector on the back of the MultiVOIP. Connect the other end of the cable to your network.

4.Turn on power to the MultiVOIP by setting the power switch on the right side panel to the ON position. Wait for the Boot LED on the MultiVOIP to go off before proceeding. This may take a couple of minutes.

98