Multi-Tech Systems MVP-3010, MVP-2400, MVP-2410 manual Local Configuration Procedure Summary, 203

MultiVOIP User Guide Technical Configuration (Analog/BRI)

Local Configuration Procedure (Summary)

After the MultiVOIP configuration software has been installed in the ‘Command’ PC (which is connected to the MultiVOIP unit), several steps must be taken to configure the MultiVOIP to function in its specific setting. Although the summary below includes all of these steps, some are optional.

1.Check Power and Cabling.

2.Start MultiVOIP Configuration Program.

3.Confirm Connection.

4.Solve Common Connection Problems.

A.Fixing a COM Port Problem.

B.Fixing a Cabling Problem.

5.Familiarize yourself with configuration parameter screens and how to access them.

6.Set IP Parameters.

7.Enable web browser GUI (optional).

8.Set Voice/Fax Parameters.

9.Set Telephony Interface Parameters (analog) or ISDN Parameters (ISDN/BRI).

10.Set SNMP Parameters (applicable if MultiVoipManager remote management software is used).

11.Set Regional Parameters (Phone Signaling Tones and Cadences).

12.Set Custom Tones and Cadences (optional).

13.Set SMTP Parameters (applicable if Log Reports are via Email).

14.Set Log Reporting Method (GUI, locally in MultiVOIP Configuration program; SNMP, remotely in MultiVoipManager program; or SMTP, via email).

15.Set Supplementary Services Parameters. The Supplementary Services screen allows voip deployment of features that are normally found in PBX or PSTN systems (e.g., call transfer and call waiting).

16.Set Baud Rate (of COM port connection to ‘Command’ PC).

17.View System Info screen and set updating interval (optional).

18.Save the MultiVOIP configuration.

19.Create a User Default Configuration (optional).

203