Multi-Tech Systems MVP-2410, MVP-2400, MVP-3010 manual Procedure in Detail, 544

8-Channel Analog Expansion Card MultiVOIP User Guide

Installation Instructions for MVP428 Upgrade Card

In this procedure, you will install an additional circuit board into the MVP410, converting it from a 4-channel voip to an 8-channel voip.

Summary: (A) Attach four standoffs to main circuit card.

(B)Mate the 60-pin connectors (male connector on main circuit card; female on upgrade card).

(C)Attach upgrade card to main circuit card (4 screws).

* *

(A)

Replace main card screws with standoffs here *

(2 places).

Add standoffs here 	(C)
(2 places).

Attach upgrade card (screws into standoffs -- 4 places).

	
	(B)

Mate 60-pin connectors.

Figure D-1. Installation Summary

Procedure in Detail

1.Power down and unplug the MVP410 unit.

2.Using a Phillips driver, remove the blank cover plate at the rear of the MVP410 chassis. Save the screws.

screws on blank cover plate (2)

Figure D-2: Removing screws from blank cover plate

544