Multi-Tech Systems MVP-2410, MVP-2400, MVP-3010 manual 550

Call States/Reasons		MultiVOIP User Guide
		Call States Listing (cont’d)
No	State	Description
11	LRQ Sent	An LRQ was sent on the network. Waiting
		for a reply.
12	received LCF	An LCF was received. The application
		should decide whether or not to accept it.
13	Setup Sent To Dest	The Gatekeeper sends the Setup message to
		the Destination.
14	Call To Forward	A call is to the forward service and hence
	Service	will be disconnected.
15	Dial Tone	A Setup message was sent.
16	Proceeding	Waiting for the end user’s phone to ring.
17	Setup Ack	A Notification given on a SetupAck
		message arrived from the destination of a
		call.
18	Dest Alert	The end user’s phone is ringing.
19	Disconnected	A connected call was disconnected.
20	Call Cannot	The destination did not connect. Waiting for
	Complete	application instruction whether to
		disconnect or perform address translation
		again after the application sets new
		addresses.
21	Connected	The call connected.
22	Address Resolution	The application may replace call addresses.
		The various reasons for this state are
		mentioned in the reason table. Each time the
		address is changed by the Gatekeeper (such
		as stripping a zone prefix or translating an
		alias to IP address), the application is
		notified with the suitable reason.
23	Address Resolution	The application may review the final
	Done	destination. This can be sent with two
		reasons:
		1)AddressFound
		2)NeedLRQ.
		The application needs to approve the final
		result or reroute the call
24	Admission Reject	Lets the application know about the reject.
25	Setup Reject	Lets the application know about the reject.
26	Orig Admission	Lets the application know about the reject.
	Reject
27	Dest Admission	Lets the application know about the reject.
	Reject

550