Multi-Tech Systems MVP-3010, MVP-2400, MVP-2410 manual Phone/IP Starter Configuration, Gui

MultiVOIP User Guide Quick Start Instructions

Phone/IP Starter Configuration

Full details here:

MVP2400	Chapter 5: Technical Configuration for
MVP2410x
	Digital T1/E1 MultiVOIPs
MVP3010
	in User Guide.
MVP130	Chapter 6: Technical Configuration for
MVP210x
	Analog/BRI MultiVOIPs
MVP410x
	in User Guide
MVP810x

1.Open MultiVOIP program: Start MultiVOIP xxx Configuration.

2.Go to Configuration IP. Enter the IP parameters for your voip site.

3.Do you want to configure and operate the MultiVOIP unit using the web browser GUI? (It has the same functionality as the local Windows GUI, but offers remote access.)

If NO, skip to step 5.

If YES, continue with step 4.

4.Enable Web Browser GUI (Optional). To do configuration and operation procedures using the web browser GUI, you must first enable it. To do so, follow these steps. (The browser used must be Internet Explorer 6.0 or above; or Netscape 6.0 or above.)

A. Be sure an IP address has been		E. Open web browser.
assigned to the MultiVOIP unit		(Note: The PC being used must be
(this must be done in the		connected to and have an IP
MultiVOIP Windows GUI).		address on the same IP network
		that the voip is on.)
B. Save Setup in Windows GUI.		F. Browse to IP address of
		MultiVOIP unit.
C. Close the MultiVOIP Windows		G. If username and password have
GUI.		been established, enter them
		when prompted by voip.
D. Install Java program from		H. Use web browser GUI to
MultiVOIP product CD.		configure or operate voip.
(Must be Java Runtime Environment
1.4.0_01 or above.)
NOTE: Required on first use of
Web Browser GUI only.
Need more	See “Web Browser	Interface” in Operation &
info?	Maintenance chapter of User Guide (on CD).

59