Multi-Tech Systems MVP-3010, MVP-2400, MVP-2410 manual END of Procedure

MultiVOIP User Guide Quick Start Instructions

12D. To enable a call between two analog phones on the same voip, we will set up two channels for FXS Loop Start telephony. To do so, go to the Interface screen. Click on "FXS Loop Start" for Channel 1.

Click on "Copy Channel" and select Channel 2. Click Copy.

Click OK to acknowledge the copy. Click OK again when the main Interface screen returns.

13.Go to Save Setup Save and Reboot. Click OK. This will save the parameter values that you have just entered.

The MultiVOIP’s “BOOT” LED will light up while the configuration file is being saved and loaded into the MultiVOIP. Don’t do anything to the MultiVOIP until the “BOOT “LED is off (a loss of power at this point could cause the MultiVOIP unit to lose the configuration settings you have made).

14.(For analog gatekeeper-equipped models only. These have model numbers with a “G” suffix. For non-gatekeeper units and for MVP2410G, skip this step.) Connect two standard analog telephone sets to the Channel 1 and Channel 2 FXS/FXO ports on the back of the "G" voip unit.

At either phone, dial 65. The completion of the call to the other phone confirms that the embedded gatekeeper of the “G” voip unit is mediating calls.

For more information, see the “Embedded Gatekeeper” chapter of the User Guide.

END OF PROCEDURE.

65