Multi-Tech Systems MVP-2410/3010, MVP-410ST/810ST manual Cabling Procedure for MVP210, 104

Mechanical Installation & Cabling MultiVOIP User Guide

Cabling Procedure for MVP210

Cabling involves connecting the MultiVOIP to your LAN and telephone equipment.

1.For DID channels only. If both channels of your MVP210 MultiVOIP will be using either FXS, FXO, or E&M telephony interfaces, skip to step 2.

For any channel on which you are using the DID interface type, you must change the jumper on the MultiVOIP circuit card.

a. Disconnect power. Unplug the AC power cord from the wall outlet or from the receptacle on the MultiVOIP unit.

b. Using a #1 Phillips driver, remove the screw (at bottom of unit, near the back-cover end) that attaches the main circuit card to the chassis of the MVP210.

c. Pull the main circuit card out about half way.

104