Quick Start Instructions | MultiVOIP User Guide |
|
|
Connectivity Test
The procedures “Phone/IP Starter Configuration” and “Phonebook Starter Configuration” must be completed before you can do this procedure.
1. These connections must be made:
Connections | |
for digital MultiVOIPs | for analog MultiVOIPs |
| & |
|
|
MultiVOIP to local PBX | MultiVOIP to local phone |
| station |
| |
| MultiVOIP to extension of |
| key phone system |
|
|
MultiVOIP to command PC | MultiVOIP to command PC |
|
|
MultiVOIP to Internet | MultiVOIP to Internet |
|
|
2.Inbound Phonebook and Outbound Phonebook must both be set up with at least one entry in each. These entries must allow for connection between two voip units.
3.Console messages must be enabled. (If this has not been done already, go, in the MultiVOIP GUI, to Configuration Logs and select the “Console Messages” checkbox.
4.You now need to free up the COM port connection (currently being used by the MultiVOIP program) so that the HyperTerminal program can use it. To do this, you can either (a) click on Connection in the sidebar and select “Disconnect” from the
78
