Multi-Tech Systems MVP-410ST/810ST, MVP-130/130FXS manual MVP-410/810 Channel Jumper Settings

Mechanical Installation & Cabling MultiVOIP User Guide

d. Identify the channels on which the DID interface will be used.

Ch 5

U7

Upper Circuit Card

MVP810 only

Ch 6	Ch 7	Ch 8
U9	U8	U10

Jumpers 5-8

}

			Main Circuit Card
			MVP-410/810
Ch 1	Ch 2	Ch 3	Ch 4
			}
			Jumpers 1-4

Jumper Configurations

(enlarged)

For DID

Interface type

For non-DID

Interface type

Generality:

For channels using the DID interface, the jumper must not straddle across the cross-hatched area between the jumper posts.

For channels using any non-DID interface, it is acceptable that the jumper straddles across the cross-hatched area between the jumper posts.

Figure 3-11. MVP-410/810 Channel Jumper Settings

e. Position the jumper for each DID channel so that it does not connect the two jumper posts. For DID operation of a voip channel, the MultiVOIP will work properly if you simply remove the jumper altogether, but that is inadviseable because the jumper might be needed later if a different telephony interface is used for that voip channel.

f. Slide the main circuit card back into the MultiVOIP chassis and replace the three screws.

96