Multi-Tech Systems MVP-2410/3010, MVP-410ST/810ST manual Cabling Procedure for MVP-410/810

MultiVOIP User Guide Mechanical Installation & Cabling

Cabling Procedure for MVP-410/810

Cabling involves connecting the MultiVOIP to your LAN and telephone equipment.

1.For DID channels only. If all channels of your MultiVOIP will be using either FXS, FXO, or E&M telephony interfaces, skip to step 2.

For any channel on which you are using the DID interface type, you must change the jumper on the MultiVOIP circuit card.

a. Disconnect power. Unplug the AC power cord from the wall outlet or from the receptacle on the MultiVOIP unit.

b. Using a #1 Phillips driver, remove the three screws (at back of unit) that attach the main circuit card to the chassis of the MultiVOIP.

Screws (3) holding circuit card assembly to chassis.

x	MVP410/810	x
	rear panel

x

Figure 3-10. MVP-410/810 Rear Screw Locations

c. Pull the main circuit card out about 5 inches (the power connection to the board prevents it from being removed entirely from the chassis).

95