Multi-Tech Systems MVP-130/130FXS manual Automatic Disconnection, Call Duration defines, 151

MultiVOIP User Guide Technical Configuration (T1/E1)

Voice/Fax Parameter Definitions (cont’d) )

Field Name	Values	Description
Auto Disconnect		The Automatic Disconnection
Parameters		group has four options which can
		be used singly or in any
		combination.
Jitter Value	1-65535	The Jitter Value defines the average
	milli-	inter-arrival packet deviation (in
	seconds	milliseconds) before the call is
		automatically disconnected. The
		default is 150 milliseconds. A higher
		value means voice transmission will
		be more accepting of jitter. A lower
		value is less tolerant of jitter.
		Inactive by default. When active,
		default = 150 ms. However, value
		must equal or exceed Dynamic
		Minimum Jitter Value.
Call	1-65535	Call Duration defines the
Duration	seconds	maximum length of time (in
		seconds) that a call remains
		connected before the call is
		automatically disconnected.
		Inactive by default.
		When active, default = 180 sec.
		This may be too short for most
		configurations requiring upward
		adjustment.
Consecutive	1-65535	Consecutive Packets Lost defines
Packets Lost		the number of consecutive packets
		that are lost after which the call is
		automatically disconnected.
		Inactive by default.
		When active, default = 30
Network	1 to 65535	Specifies how long to wait before
Discon-	seconds;	disconnecting the call when IP
nection	Default =	network connectivity with the
	300 sec.	remote site has been lost.

151