Multi-Tech Systems MVP-2410/3010, MVP-410ST/810ST, MVP-130/130FXS manual 260, Did Options cont’d

Technical Configuration (Analog/BRI) MultiVOIP User Guide

DID Interface Parameter Definitions (cont’d)

Field Name	Values	Description
DID Options (cont’d)
Start Modes	Immediate Start,	For Wink Start, the voip detects
	Wink Start,	the off-hook condition. Then
	Delay Dial	the voip reverses battery
		polarity for a specified time
		(140-290 ms; a “wink”) and then
		becomes ready to receive dial
		digits.
		For Delay Dial, the voip detects
		detects the off-hook condition.
		Then the voip reverses battery
		polarity for a specified time
		(reverse polarity duration has
		wider acceptable range than for
		Wink Start) and then becomes
		ready to receive dial digits.
Wink Timer	integer values,	This is the length of the wink
(in ms)	in milliseconds	for Wink Start and Delay Dial
		signaling modes..
		Applicable only when Start
		Mode parameter is set to “Wink
		Start” or “Delay Dial.”
Dialing Options
Inter Digit	integer values,	This is the length of time that
Timer	in seconds	the MultiVOIP will wait
		between digits. When the time
		expires, the MultiVOIP will
		look in the phonebook for the
		number entered.
		Default = 2.
Message	--	Not applicable to DID-DPO
Waiting		interface.
Indication
Inter-Digit	integer values,	This parameter is applicable
Regeneration	in milliseconds	when digits are dialed onto a
Timer		DID-DPO channel after the
		connection has been made. The
		length of time between the
		outputting of DTMF digits.
		Default = 100 ms.

260