Multi-Tech Systems MVP-2410/3010, MVP-410ST/810ST, MVP-130/130FXS manual 278

Technical Configuration (Analog/BRI) MultiVOIP User Guide

The Custom Tone-Pair Settings fields are described in the table below.

Custom Tone-Pair Settings Definitions

Field Name	Values	Description
Tone Pair	dial tone,	Identifies the type of telephony
	busy tone,	signaling tone for which
	ring tone,	frequencies are being specified.
	‘unobtainable’
	tone,
	survivability
	tone,
	re-order tone
TONE PAIR	VALUES	About Defaults: US telephony
		values are used as defaults on
		this screen. However, since this
		dialog box is provided to allow
		custom tone-pair settings,
		default values are essentially
		irrelevant.
Frequency 1	frequency in	Frequency of lower tone of pair.
	Hertz	This outbound tone pair enters
		the MultiVOIP at the input port.
Frequency 2	frequency in	Frequency of higher tone of pair.
	Hertz	This outbound tone pair enters
		the MultiVOIP at the input port.
Gain 1	gain in dB	Amplification factor of lower
	+3dB to –31dB	frequency of pair. This figure
	and “mute”	describes amplification that the
		MultiVOIP applies to outbound
	setting
		tones entering the MultiVOIP at
		the input port. Default = -16dB
Gain 2	gain in dB	Amplification factor of higher
	+3dB to –31dB	frequency of pair. This figure
	and “mute”	describes amplification that the
	setting	MultiVOIP applies to outbound
		tones entering the MultiVOIP at
		the input port. Default = -16dB

278