Multi-Tech Systems MVP-2410/3010, MVP-410ST/810ST manual T1 Telephony Parameters for MVP2410, 125

MultiVOIP User Guide Technical Configuration (T1/E1)

Write down the values for these IP parameters. You will need to enter these values in the “IP Parameters” screen in the Configuration section of the MultiVOIP software. You must have this IP information about every VOIP in the system.

T1 Telephony Parameters (for MVP2410)

The following parameters must be known about the PBX or telco central office equipment to which the T1 MultiVOIP will connect:

9 T1 Phone Parameters	Info needed to operate:
Ask phone company or	MVP2410
PBX maintainer.

#T1 Telephony Parameters: Record for this VOIP Site

•Which frame format is used? ESF___ or D4___

•Which CAS or PRI protocol is used? ______________

•Clocking: Does the PBX or telco switch use

internal or external clocking? _________________

Note that the setting used in the voip unit will be the opposite of the setting used by the telco/PBX.

•Which line coding is used? AMI___ or B8ZS___

Write down the values for these T1 parameters. You will need to enter these values in the “T1/E1 Parameters” screen in the Configuration section of the MultiVOIP software.

125