Multi-Tech Systems MVP-410ST/810ST, MVP-130/130FXS, MVP-2410/3010 00170860 H3230 New incoming call

MultiVOIP User Guide Quick Start Instructions

Console Messages from Terminating VOIP. The voip unit connected to the phone where the call is answered will send back messages like that shown below.

[00170860]	H323[0]: New incoming call
[00170860]	PSTNIF : Placing call on channel 0 Outbound
	digit 7175662
[00170885]	CAS[0] : TX : ABCD = 1, 1, 1, 1
[00171095]	H323IF [0]: MasterSlaveStatus=Master
[00171105]	CAS[0] : RX : ABCD = 1, 1, 1, 1,Pstn State[7]
	TimeStamp : 171105
[00171105]	H323IF[0]: Coder used 'g7231'
[00171110]	H323IF[0]:FastStart Setup Not Used
[00171110]	H323IF[0]: Already opened the outgoing logical
	channel
[00171110]	H323IF[0]: Coder used 'g7231'
[00171315]	CAS[0] : RX : ABCD = 0, 0, 0, 0,Pstn State[9]
	TimeStamp : 171315
[00172275]	PSTN: dialing digit ended on 0
[00172285]	PSTN: pstn proceeding indication on 0
[00172995]	CAS[0] : RX : ABCD = 1, 1, 1, 1,Pstn State[12]
	TimeStamp : 172995
[00173660]	CAS[0] : TX : ABCD = 1, 1, 1, 1
[00173760]	PSTN:pstn call connected on 0

9.When you see the following message, end-to-end voip connectivity has been achieved.

“PSTN: pstn call connected on X”

where x is the number of the voip channel carrying the call

10.If the HyperTerminal messages do not confirm connectivity, go to the Troubleshooting procedure below.

81