Multi-Tech Systems MVP-2410/3010 manual Phone/IP Starter Configuration, Analog/BRI MultiVOIPs

MultiVOIP User Guide Quick Start Instructions

Phone/IP Starter Configuration

Full details here:

MVP2410	Chapter 5: Technical Configuration for
	Digital T1/E1 MultiVOIPs
MVP3010
	in User Guide.
MVP130	Chapter 6: Technical Configuration for
MVP130FXS
	Analog/BRI MultiVOIPs
MVP210
	in User Guide
MVP410
MVP810

1.Open MultiVOIP program: Start MultiVOIP xxx Configuration.

2.Go to Configuration IP. Enter the IP parameters for your voip site.

3.Do you want to configure and operate the MultiVOIP unit using the web browser GUI? (It has the same functionality as the local Windows GUI, but offers remote access.)

If NO, skip to step 5.

If YES, continue with step 4.

4.Enable Web Browser GUI (Optional). To do configuration and operation procedures using the web browser GUI, you must first enable it. To do so, follow these steps. (The browser used must be Internet Explorer 6.0 or above; or Netscape 6.0 or above.)

A. Be sure an IP address has		E. Open web browser.
been assigned to the		(Note: The PC being used must
MultiVOIP unit (this must be		be connected to and have an IP
done in the MultiVOIP		address on the same IP network
Windows GUI).		that the voip is on.)
B. Save Setup in Windows GUI.		F. Browse to IP address of
		MultiVOIP unit.
C. Close the MultiVOIP		G. If username and password
Windows GUI.		have been established, enter
		them when prompted by
		voip.
D. Install Java program from		H. Use web browser GUI to
MultiVOIP product CD.		configure or operate voip.
(Must be Java Runtime
Environment 1.4.2_01 or above.)
NOTE: Required on first use of
Web Browser GUI only.
Need more	See “Web Browser Interface” in Operation &
info?	Maintenance chapter of User Guide (on CD).

59