Multi-Tech Systems MVP-410ST/810ST, MVP-2410/3010 manual MVP-130/130FXS Front Panel LED Definitions

MultiVOIP User GuideOverview

MVP-130/130FXS Front Panel LED Definitions

LED NAME	DESCRIPTION
General Operation LEDs
Power	Indicates presence of power.
Boot	After power up, the Boot LED will be on briefly while
	the MultiVOIP is booting. It lights whenever the
	MultiVOIP is booting or downloading a setup
	configuration data set.
Ethernet	FDX. LED indicates whether Ethernet connection is
	half-duplex or full-duplex (FDX) and, in half-duplex
	mode, indicates occurrence of data collisions. LED is
	on constantly for full-duplex mode; LED is off
	constantly for half-duplex mode. When operating in
	half-duplex mode, the LED will flash during data
	collisions.
	LNK. Link/Activity LED. This LED is lit if Ethernet
	connection has been made. It is off when the link is
	down (i.e., when no Ethernet connection exists).
	While link is up, this LED will flash off to indicate data
	activity.
Channel-Operation LEDs
TX	Transmit. This indicator blinks when voice packets
	are being transmitted to the local area network.
RX	Receive. This indicator blinks when voice packets
	are being received from the local area network.
XS	Transmit Signal. This indicator lights when the
	FXS-configured channel is off-hook or the FXO-
	configured channel (MVP130 only) is receiving a ring
	from the Telco or PBX.
RS	Receive Signal. This indicator lights when the FXS-
	configured channel is ringing or the FXO-configured
	channel (MVP130 only) has taken the line off-hook.

33