Multi-Tech Systems MVP-410ST/810ST manual E1 LED Descriptions, MVP3010 Front Panel LED Definitions

OverviewMultiVOIP User Guide

E1 LED Descriptions

	MVP3010 Front Panel LED Definitions
LED NAME		DESCRIPTION
Power		Indicates presence of power.
Boot		After power up, the Boot LED will be on for
		about 10 seconds while the MVP3010 is booting.
FDX		Full-Duplex & Collision LED. This LED indicates
		whether the Ethernet connection is half-duplex or full-
		duplex (FDX) and, in half-duplex mode, indicates
		occurrence of data collisions. LED is on constantly for
		full-duplex mode; LED is off constantly for half-
		duplex mode. When operating in half-duplex mode,
		the LED will flash during data collisions.
LNK		Link/Activity LED. This LED is lit if Ethernet
		connection has been made. It is off when the link is
		down (i.e., when no Ethernet connection exists).
		While link is up, this LED will flash off to indicate data
		activity.
T1		T1. Not supported.
E1		E1. When lit, indicates presence of E1
		connection.
PRI		PRI. On if E1 line is of ISDN-Primary-Rate type.
ONL		Online. This LED is on when frame
		synchronization has been established on the
		T1/E1 link.
IC		IC LED is on when Internal Clocking is selected
		in T1/E1 configuration.
LC		Indicates Loss of Carrier.
LS		Indicates Loss of Signal.
Test		For testing purposes only.

24