Multi-Tech Systems MVP-130/130FXS, MVP-410ST/810ST manual Did Interface Parameter Definitions, 259

MultiVOIP User Guide Technical Configuration (Analog/BRI)

DID Parameters. The parameters applicable to the Direct Inward Dial (DID) telephony interface type are shown in the figure below and described in the table that follows. The DID interface allows one phone line to direct incoming calls to any one of several extensions without a switchboard operator. Of course, one DID line can handle only one call at a time. The parameters described here pertain to the customer- premises side of the DID connection (DID-DPO, dial-pulse originating); the network side of the DID connection (DID-DPT, dial-pulse terminating) is not supported.

DID Interface Parameter Definitions

*Not applicable to MVP130FXS

Field Name	Values	Description
Interface	DID-DPO	Enables the customer-premises
		side of DID functionality
DID Options		MultiVOIP’s use of DID applies
		only for incoming DID calls.
		The Start Mode used by the
		MultiVOIP must match that
		used by the originating
		telephony equipment, else DID
		calls cannot be completed.
Start Modes	Immediate Start,	For Immediate Start, the voip
	Wink Start,	detects the off-hook condition
	Delay Dial	initiated by the telco central-
		office call and becomes ready to
		receive dial digits immediately.

259