Multi-Tech Systems MVP-130/130FXS, MVP-410ST/810ST, MVP-2410/3010 manual 211

MultiVOIP User Guide Technical Configuration (Analog/BRI)

Write down the values for these IP parameters. You will need to enter these values in the “IP Parameters” screen in the Configuration section of the MultiVOIP software. You must have this IP information about every VOIP in the system.

Analog Telephony Interface Parameters

(for MVP-130/130FXS/210/410/810)

The following parameters must be known about the PBX or telco central office equipment to which the analog MultiVOIP will connect:

9 Analog Phone Parameters	Needed for:
Ask phone company or	MVP810
	MVP410
telecom manager.	MVP210
	MVP130
	MVP130FXS

#Analog Telephony Interface Parameters:

Record for this VOIP Site

•Which interface type (or “signaling”) is used?

E&M_____ FXS/FXO_____

•If FXS, determine whether the line will be used for a phone, fax, or KTS (key telephone system)

•If FXO, determine if line will be an analog PBX extension or an analog line from a telco central office

•If E&M, determine these aspects of the E&M trunk line from the PBX:

• What is its Type (1, 2, 3, 4, or 5)?

• Is it 2-wire or 4-wire?

• Is it Dial Tone or Wink?

211