Multi-Tech Systems MVP-130/130FXS, MVP-410ST/810ST manual Introduction, MultiVOIP Startup Tasks

Quick Start Instructions MultiVOIP User Guide

Introduction

This chapter gets the MultiVOIP up and running quickly. The details we’ve skipped to make this brief can be found elsewhere in the manual (see Table of Contents and Index).

MultiVOIP Startup Tasks

Task	Summary
z Collecting Phone/IP	The MultiVOIP must be configured to
Details (vital!)	interface with your particular phone
	system and IP network. To do so,
	certain details must be known about
	those phone and IP systems.
z Placement	Decide where you’ll mount the voip.
z Command/Control	Some modest minimum specifications
Computer Setup:	must be met. A COM port must be set
Specs & Settings	up.
z Hookup	Connect power, phone, and data cables
	per diagram.

zSoftware Installation

This is the configuration program. It’s a standard Windows software installation.

zPhone/IP Starter Configuration

You will enter phone numbers and IP addresses. You’ll use default parameter values where possible to get the system running quickly.

zPhonebook Starter Configuration

zConnectivity Test

zTroubleshooting

The phonebook is where you specify how calls will be routed. To get the system running quickly, you’ll make phonebooks for just two voip sites.

You’ll find out if your voip system can carry phone calls between two sites. That means you’re up and running!

Detect and remedy any problems that might have prevented connectivity.

46