Multi-Tech Systems MVP-130/130FXS manual For an FXS or FXO connection, For an E&M connection

MultiVOIP User Guide Mechanical Installation & Cabling

2.Connect the power cord supplied with your MultiVOIP to a live AC outlet and to the power connector on the back of the MultiVOIP as shown at top right in Figure 3-12.

Command Modem connector

for remote configuration

E&M	FXS/FXO	E&M	FXS/FXO	E&M	FXS/FXO	E&M	FXS/FXO COMMAND	ETHERNET
								COMMAND
E&M	FXS/FXO	E&M	FXS/FXO	E&M	FXS/FXO	E&M	MODEM	10 BASET
							FXS/FXO

Voice/Fax Channel Connections

Channels 1-4 Bottom MVP410/810

Channels 5-8 Top MVP810 Only

E&M FXS/FXO

Ethernet Connection

E&M FXS

FXO

Command Port Connection

PSTN

Figure 3-12: Cabling for MVP-410/810

3.Connect the MultiVOIP to a PC by using a DB-25 (male) to DB-9 (female) cable. Plug the DB-25 end of the cable into the Command port of the MultiVOIP and the other end into the PC serial port. See Figure 3-12.

4.Connect a network cable to the ETHERNET 10BASET connector on the back of the MultiVOIP. Connect the other end of the cable to your network.

5.For an FXS or FXO connection.

(FXS Examples: analog phone, fax machine, Key Telephone System.)

(FXO Examples: PBX extension, POTS line from telco central office.) Connect one end of an RJ-11 phone cord to the Channel 1 FXS/FXO connector on the back of the MultiVOIP.

Connect the other end to the device or phone jack.

For an E&M connection.

(E&M Example: trunk line from telephone switch.)

Connect one end of an RJ-45 phone cord to the Channel 1 E&M connector on the back of the MultiVOIP.

97