Muratec MFX-1500 manual Removing the transport screws, Installing the printing supplies

Getting started

Removing the transport screws

Your fax machine is shipped with transport screws for protecting your fax machine’s mirror carriage during shipping.

Important: Be sure that you do not turn the power on until after you have removed the transport screws. Otherwise, damage could result.

1. Remove the four transport screws, as shown.

2. Get the protection seals from your manual kit, and attach one protection seal on each transport screw’s now-open hole. This shields the hole while you are using the machine.

Important: Before you use the machine, you must turn off the transport mode (see page 1.16).

Note: Be sure to save the screws for reshipment. If you must ship your machine for some reason, turn on the transport mode, turn the power off and then undo the above procedure as follows:

—Remove the seals (reversing step 2);

—Reinstall the screws (reversing step 1).

Installing the printing supplies

Your fax machine prints incoming faxes and copies with a high-speed laser print engine. The engine requires two types of printing supplies, or consumables:

∙The drum cartridge — It yields up to 10,000 normal letter-sized printouts (see “Specifications,” page AI.1). By “normal,” we’re referring to the amount of text and/or graphics on each page. This is based on an industry-standard test document.

∙The toner cartridge — It yields up to 10,000 such printouts (see “Specifications,” page AI.1).

Here’s how to install these supplies:

1. Open the top cover.

2. Open the printer cover.

1.10