Muratec MFX-1500 manual Lifting an optional handset Either case, the display shows

Getting started

8. Press START.

Your machine will scan the document into memory.

Note: The more “stuff” (or black coverage, to use the fax term) your machine “sees” on a page, the more slowly the page will feed through as the fax scans it — especially when you transmit in non- memory mode. Sending a page in grayscale mode or certain resolution settings makes your machine “see” more “stuff.” The same is true if you set the contrast to Dark.

While your machine scans the document, the display will show:

Fax number you entered

919725552009in step 7.

Ltr NextDoc Mem100%

Amount of memory available.

If NextDoc appears, it means the machine is ready to scan another page (after completing the current scanning job).

If you don’t wish to send any more pages, press NEXT to clear the NextDoc message; your fax will dial as soon as the machine finishes scanning.

Document size of document currently being scanned.

9. When the scanning is done, the display will show:

Start Scan → Next

Tx Start → Start

To send more pages, proceed to step 10.

If the machine has finished scanning all the pages you want to send on this transmission, press START, and skip to step 12.

10. Place the next page, then press NEXT to start scanning.

11. To send any more pages, repeat steps 9–10.

12. Now, everything is up to the machines — yours and the one you’re dialing. When it makes contact, your machine transmits the stored document from memory.

Note: What if the call fails for some reason? See pages 1.27–1.28.

Sending a fax with on-hook dialing or a handset: manual transmission

Important: Manual transmission available only when you use the ADF.

You also can fax a document by dialing using either the monitor speaker (this is called “on-hook” dialing) or the optional handset. Here’s how:

1.	If the machine is already in Fax mode, skip to step 2.
	If the machine is in Copy mode, press COPY/FAX to change to Fax mode.
2.	Insert the document into the ADF.
3.	Adjust resolution and contrast if necessary.
	If these are OK, skip to step 4. Otherwise, as desired:
	Press RESOLUTION to change the resolution.
	Press CONTRAST, then press	or	to change the contrast.

4. Obtain a dial tone. You can do this by either:

•Activating the monitor speaker (by pressing MONITOR/CALL).

… or …

•Lifting an optional handset.

In either case, the display shows:

** Tel Mode **

_

5. Enter the fax number by using the numeric keypad.

Note: For information on entering one-touch and speed-dial numbers, see pages 2.12–2.15.

** Tel Mode ** 919724032009_

Enter access codes along with the number, just as for a regular phone call.

6. When you hear fax tones from the remote unit, press START.

Note: If a person answers the phone, tell him or her you’re trying to send a fax. When his/her machine sends you fax tones, then press START.

1.26